PDA

View Full Version : started the "Painless" (BS) today



ShadowBolt
11-23-2007, 06:42 PM
I thought I would get all the stock wires out in about 15 minutes but it took three hours! This wiring crap should be done prior to the cage...my bad.
I got a better look at the brake booster. How in the hell do you get to the top passenger side nut? I have changed a few of these in the past (not on a Mustang) but I could not even reach in and get my hand on it.

JJ

ShadowBolt
11-25-2007, 06:41 PM
Most of the wiring is done. I need some help with the color of the wire that goes to the fuel pump ( there is a loom inside the car that goes back for tail lights and such but I don't know if the fuel pump wire is in that loom)? Also if someone knows the color of the fuel gauge wire?

I removed the Cobra booster.....what a bitch! I made the mistake of leaving the car on the trailer thinking the wiring would be a two hour job. Dumb Ass! Between the wiring and booster change I've been up and down a thousand times.

JJ

marshall_mosty
11-25-2007, 09:42 PM
Fuel guage wire on my car is yellow with a white stripe.

Todd Covini
11-25-2007, 09:52 PM
Booster job takes a big-ass hammer, the hood off and the car preferably off a trailer.

...am I too late with this information? :oops: :lol:

-=- T