• Supercharged111's Avatar
    11-09-2018, 02:08 PM
    Well, any takers for an RM race? Or are ya too scared of Bryan? :p
    4 replies | 112 view(s)
  • Supercharged111's Avatar
    11-04-2018, 08:15 PM
    Why would you want all that fuel sloshing around behind the axle anyway?
    29 replies | 3643 view(s)
  • Supercharged111's Avatar
    10-30-2018, 10:09 PM
    Supercharged111 replied to a thread FNG - Intro in General
    Or stop speaking legibly at downhill water slide time and be passed out hours before delicious midnight ribs are served.
    21 replies | 967 view(s)
  • Supercharged111's Avatar
    10-30-2018, 10:06 PM
    Supercharged111 replied to a thread Cobra Brake Rotors in General
    Are you certain this wasn't her intent? https://www.youtube.com/watch?v=wS90LbkqOaA Because that looks like something I'd try.
    22 replies | 675 view(s)
  • Supercharged111's Avatar
    10-28-2018, 11:53 PM
    Supercharged111 replied to a thread Cobra Brake Rotors in General
    Well there's your problem, the #39 is your point of reference. :p
    22 replies | 675 view(s)
  • Supercharged111's Avatar
    10-28-2018, 11:11 AM
    Supercharged111 replied to a thread Cobra Brake Rotors in General
    I run the "good" rotors that Advance sells. I've never gotten a full season out of any rotor, these are cheaper and last as long as Napa's best....
    22 replies | 675 view(s)
  • Supercharged111's Avatar
    10-28-2018, 11:08 AM
    Supercharged111 replied to a thread Tire Rack? in General
    Phil's Tire, customer service is top notch. https://philstireservice.com/ Brakes. Call, don't just order online. Much better pricing if you...
    9 replies | 536 view(s)
  • Supercharged111's Avatar
    10-27-2018, 06:26 PM
    Supercharged111 replied to a thread FNG - Intro in General
    Not as sexy as that red 4th gen it's pictured with. 8-)
    21 replies | 967 view(s)
  • Supercharged111's Avatar
    10-27-2018, 06:23 PM
    I'm ASSuming it'll be beautimous in there. I may have misspoken on the bearings, maybe it was the gears themselves. Syncros just slide right out,...
    13 replies | 630 view(s)
  • Supercharged111's Avatar
    10-27-2018, 02:33 PM
    255/307 is doing really good for a TPI. They tend to make so much more torque than hp that you end up backing timing off to keep from going over on...
    15 replies | 625 view(s)
  • Supercharged111's Avatar
    10-27-2018, 10:29 AM
    What exactly did that car come with for a motor? I believe Bob Denton over in the Great Lakes region has a 3rd gen running a carb'd setup. Matter of...
    15 replies | 625 view(s)
  • Supercharged111's Avatar
    10-27-2018, 10:27 AM
    Supercharged111 replied to a thread FNG - Intro in General
    No shit? We had a CW4 Apache pilot here briefly too. If you're a recruiter you can slap graphics on the car and write it off.
    21 replies | 967 view(s)
  • Supercharged111's Avatar
    10-26-2018, 10:06 PM
    I heard the bearings were a pain, so no thanks. Carbon blocker rings, steel 3-4 fork, billet keys and send it. Now that the pilot bearing exists it's...
    13 replies | 630 view(s)
  • Supercharged111's Avatar
    10-26-2018, 10:02 PM
    Supercharged111 replied to a thread FNG - Intro in General
    Not many of us active duty here, way to represent. Can't wait for you to get that comp license, then it'll be an Army vs Air Force showdown at...
    21 replies | 967 view(s)
  • Supercharged111's Avatar
    10-24-2018, 11:35 PM
    If it makes you feel any better I'm going to do a rebuild on my T56. Unless I destroyed something I think I'm on the hook for like $500. :p
    13 replies | 630 view(s)
  • Supercharged111's Avatar
    10-20-2018, 09:02 PM
    I should have snagged Jerry's charger. Maybe then I wouldn't have rolled up to the Hallett final with a dead battery and, unbeknownst to me, a dead...
    9 replies | 469 view(s)
  • Supercharged111's Avatar
    10-17-2018, 09:48 PM
    Forgot I even made this thread. I have ST40 calipers and mounts, no rotors so looks like Stoptech it is for the hats, rings, and hardware. Does...
    7 replies | 425 view(s)
  • Supercharged111's Avatar
    10-17-2018, 09:46 PM
    Supercharged111 replied to a thread Exhaust cost in General
    Will they charge him more or less if he supplies that information?
    15 replies | 975 view(s)
  • Supercharged111's Avatar
    10-14-2018, 09:51 PM
    Knockback has been driving me bonkers the last couple events. I think my expectations are going up for the red dragon. Last I researched there was a...
    7 replies | 425 view(s)
  • Supercharged111's Avatar
    10-14-2018, 01:23 PM
    Supercharged111 replied to a thread Exhaust cost in General
    You can start with one of these. They require some massaging to fit properly and the ground clearance isn't as good as stock. A few off road...
    15 replies | 975 view(s)
  • Supercharged111's Avatar
    10-13-2018, 11:20 AM
    Supercharged111 replied to a thread Exhaust cost in General
    I'm a cheapass and found the rear section of the factory y which has much better ground clearance than the aftermarket y pipes. Going to spend money...
    15 replies | 975 view(s)
  • Supercharged111's Avatar
    10-08-2018, 10:01 PM
    Supercharged111 replied to a thread Axle c clips in General
    Yep. Gonna have to start checking C clips at Nats now. . .
    4 replies | 273 view(s)
  • Supercharged111's Avatar
    10-07-2018, 09:48 PM
    That was this season alone. Was the first and second time the car didn't drive itself onto the trailer. DNFs aren't really my thing. Shooting for...
    37 replies | 2086 view(s)
  • Supercharged111's Avatar
    10-06-2018, 10:55 AM
    Who in their right mind would cross over to SM in hopes of landing a podium at Nats? Oh wait. . . :p Winching a lifeless car onto the trailer...
    37 replies | 2086 view(s)
  • Supercharged111's Avatar
    10-03-2018, 09:47 PM
    Supercharged111 replied to a thread Diff Cover Drain in General
    I know some seem to think Bryan is the only one who can hustle a 4th gen, but he's not completely ruling the roost back here. I'm not seeing any...
    66 replies | 4904 view(s)
  • Supercharged111's Avatar
    10-03-2018, 09:51 AM
    When does NASA TX anticipate to have next year's schedule posted or at least tentative?
    7 replies | 448 view(s)
  • Supercharged111's Avatar
    09-24-2018, 07:39 PM
    I actually have an RCR cooked up to further clarify 6.14. The intent of 6.14 is to allow GenIII 5.3 engines which is why the RPOs are called out. LM7...
    5 replies | 329 view(s)
  • Supercharged111's Avatar
    09-22-2018, 12:05 PM
    Supercharged111 replied to a thread Interesting Ram Air in Engine
    Bryan in case I was unclear, having reread the rules it seems they are written in a way that would allow an LS style airbox to be run with an LT1. ...
    41 replies | 2309 view(s)
  • Supercharged111's Avatar
    09-12-2018, 05:05 PM
    Supercharged111 replied to a thread Interesting Ram Air in Engine
    Bear in mind for something that questionable I would require data to allow it, but if the data supports it then it is what it is. My point is that I...
    41 replies | 2309 view(s)
  • Supercharged111's Avatar
    09-12-2018, 12:20 PM
    Supercharged111 replied to a thread Interesting Ram Air in Engine
    Absolutely. You'll be set for the first 2 turns and after that you'll overheat and get your doors sucked off. :p Or dyno with the AC on, run with it...
    41 replies | 2309 view(s)
More Activity
About Supercharged111

Basic Information

About Supercharged111
Location:
Colorado Springs, CO
Interests:
Racing and wrenching

Signature


RM CMC Director

Statistics


Total Posts
Total Posts
796
Posts Per Day
0.49
General Information
Last Activity
Today 03:47 PM
Join Date
06-07-2014