Tab Content
  • Sook's Avatar
    07-12-2018, 01:26 PM
    Are we allowed to run the truck accessories with a 5.3 GM truck motor, or do we still have to source all the LS1 camaro stuff? I'm not sure if they...
    14 replies | 301 view(s)
  • Sook's Avatar
    07-10-2018, 09:07 AM
    Sook replied to a thread Camaros for sale? in Want to Buy
    Stone cold killer, especially coming from a team with three Camaros on it. Last I spoke to Mike he had the car. Phone number here: ...
    8 replies | 158 view(s)
  • Sook's Avatar
    07-08-2018, 11:35 AM
    Sook replied to a thread LT1 trouble shooting help in Engine
    Your O2 sensors are wildly different as well. Might be normal, but I doubt it.
    31 replies | 639 view(s)
  • Sook's Avatar
    07-06-2018, 12:25 AM
    Sook replied to a thread Diff Cover Drain in General
    Interesting concept. Worth a try to see if it solves your problem. I think the torque arm shaft going through the center of the heim joint might gall...
    62 replies | 1491 view(s)
  • Sook's Avatar
    07-05-2018, 03:07 PM
    Sook replied to a thread Diff Cover Drain in General
    As an alternative, we could allow torque arms on mustangs to induce wheel hop.
    62 replies | 1491 view(s)
  • Sook's Avatar
    07-05-2018, 02:59 PM
    Sook replied to a thread Transmission failures! in General
    DOOOODE, stop giving away the secrets!
    31 replies | 717 view(s)
  • Sook's Avatar
    07-05-2018, 02:59 PM
    Hm... I kind-of wish I didn't pay my $500 already. - Josh
    29 replies | 1256 view(s)
  • Sook's Avatar
    07-05-2018, 10:55 AM
    Sook replied to a thread Transmission failures! in General
    Open up the restrictor or nitrous jet a bit more. The best part about restricted engines. - Josh
    31 replies | 717 view(s)
  • Sook's Avatar
    07-05-2018, 10:47 AM
    Sook replied to a thread How to regrease SN95 hubs. in Suspension
    I think I have a broken one I can take a picture of somewhere. You'll end up with a grease seal, inner race, inner ball bearings and cage, the outter...
    42 replies | 7100 view(s)
  • Sook's Avatar
    06-30-2018, 03:19 PM
    Sook replied to a thread How to regrease SN95 hubs. in Suspension
    Here's a picture of the tool Richard P. made. I tried to take out the dust seal from the back of this bearing, but it didn't come out properly....
    42 replies | 7100 view(s)
  • Sook's Avatar
    06-30-2018, 02:14 PM
    Sook replied to a thread Transponder in General
    I bought a used wired 260 from ebay, for $500.... The only piece of electronic equipment that is appreciating over the years. - Josh
    6 replies | 140 view(s)
  • Sook's Avatar
    06-27-2018, 12:54 PM
    Sook replied to a thread Transmission failures! in General
    I agree with it as well. I also lost a trans at Hallett near the end of the last race, heat related IMO. I'm going to try to heat shield the exhaust...
    31 replies | 717 view(s)
  • Sook's Avatar
    06-26-2018, 06:33 PM
    Sook replied to a thread LT1 trouble shooting help in Engine
    ICM issues are what led to us doing the LS1 swap. I never figured out why but the car was eating them every two sessions. The ACDelco ones would last...
    31 replies | 639 view(s)
  • Sook's Avatar
    06-22-2018, 03:19 PM
    Sook replied to a thread LT1 trouble shooting help in Engine
    The LT1 beat me last year. Once they start acting up it's hard to figure out the problem (within CMC rules). I was always finding broken things but...
    31 replies | 639 view(s)
  • Sook's Avatar
    06-22-2018, 03:16 PM
    Sook replied to a thread LT1 trouble shooting help in Engine
    Were the dead cylinder's exhaust tubes getting hot? I've been fooled by the injector test before. Disassemble the whole intake path, I had a MAF...
    31 replies | 639 view(s)
  • Sook's Avatar
    06-21-2018, 07:11 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    The old one.
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-21-2018, 03:25 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    My Hallett stuff was also approved today. - Josh
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-20-2018, 04:47 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    Thanks Marshall! I just went ahead and submitted mine, the worst they're going to do is deny it. - Josh
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-20-2018, 12:05 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    I checked the website and I was approved. Anyone know when the Hallett results are going to official? - Josh
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-19-2018, 02:06 PM
    Sook replied to a thread F body roll cage in General
    I think it all depends on what you want, barebones for a grand and a half to a full cage to front and rear shock towers (not-CMC legal) with NASCAR...
    12 replies | 322 view(s)
  • Sook's Avatar
    06-19-2018, 12:30 PM
    Sook replied to a thread F body roll cage in General
    I'd heard that Hank owns a shop or works at a shop or something along those lines, anyone have a link? - Josh
    12 replies | 322 view(s)
  • Sook's Avatar
    06-15-2018, 12:00 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    Do you want us to each email Molly with our issues so that the national office knows we're having problems? Happy to send the first email. - Josh
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-14-2018, 04:49 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    I was under the impression that it was supposed to be once compliance form per season?? Will Faules explained that to us in the COTA driver's meeting...
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-13-2018, 11:20 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    Was that a question? You need all that to generate the per race form. You'll also need to include the race results....
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-13-2018, 11:16 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    They haven't filled mine either. - Josh
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-13-2018, 10:57 AM
    Sook replied to a thread Hallett Media in Racing
    Does anyone have the slip'n flip pictures? I had a good laugh looking through them in the club house on Sunday. - Josh
    20 replies | 907 view(s)
  • Sook's Avatar
    06-12-2018, 02:35 PM
    Sook replied to a thread Hallett Media in Racing
    I was regretting going off track at first, when I saw the guys turn to the right I was happy with my decision. Both cars made the rest of the weekend...
    20 replies | 907 view(s)
  • Sook's Avatar
    06-11-2018, 05:37 PM
    Sook replied to a thread 2018 Toyo Bucks in General
    1) Get Mosty to sign one of these for you: https://form.jotform.com/drivenasa/nasa-contingency-compliance - save it, you'll submit this later 2)...
    38 replies | 1750 view(s)
  • Sook's Avatar
    06-06-2018, 10:49 AM
    Sook replied to a thread Hallett 2018 in Upcoming Events
    4 years is pretty amazing for the amount of abuse these things take. I have an extra factory ford nut luckily. I bought a new set of Timken bearings...
    88 replies | 3179 view(s)
  • Sook's Avatar
    06-06-2018, 10:10 AM
    Sook replied to a thread Hallett 2018 in Upcoming Events
    Trying to change the front hubs last night, the spindle nut on the driver's side galled really bad (200+ ft-lbs of running torque). Found a spare...
    88 replies | 3179 view(s)
More Activity
About Sook

Basic Information

Signature


CMC #50

Statistics


Total Posts
Total Posts
201
Posts Per Day
0.23
General Information
Last Activity
Yesterday 10:53 PM
Join Date
03-03-2016