• 64GunPilot's Avatar
    Yesterday, 08:35 AM
    Im a new 3rd Gen FNG as well. Not licensed, and have very little track time. So I don't feel qualified to "welcome" you as Im still at the bottom. ...
    19 replies | 208 view(s)
  • 64GunPilot's Avatar
    02-09-2019, 05:43 AM
    64GunPilot replied to a thread MSRH Roll Call in Upcoming Events
    Was wondering the same thing. No chatter about it at all!
    51 replies | 1673 view(s)
  • 64GunPilot's Avatar
    02-02-2019, 12:04 AM
    64GunPilot replied to a thread Spec Carbureted Engines in Engine
    Ive read that the L33 is the best 5.3. Its aluminum and heads are pretty much the same as the LS1 castings.
    22 replies | 1819 view(s)
  • 64GunPilot's Avatar
    01-31-2019, 10:57 PM
    64GunPilot replied to a thread Spec Carbureted Engines in Engine
    I found this $800 for turn key with accessories, harness, ect. Would need accessories, intake, and exhaust from LS1. So maybe $1250 for all of it....
    22 replies | 1819 view(s)
  • 64GunPilot's Avatar
    01-29-2019, 10:48 PM
    64GunPilot replied to a thread Spec Carbureted Engines in Engine
    A couple months late on this answer, but as far as the intake, its the Vortec to TPI intake thats on the car now. I've been looking at the 5.3 LS...
    22 replies | 1819 view(s)
  • 64GunPilot's Avatar
    01-28-2019, 07:22 PM
    64GunPilot replied to a thread Facilities & Etiquette in General
    Yea for sure. I have two different types of WD hitches.....one is an Anderson WD Hitch which is unconventional (pain in the ass to setup and doesnt...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-25-2019, 03:53 AM
    64GunPilot replied to a thread Facilities & Etiquette in General
    The only mod i have planned are airbags. If I go easy on it, the trans should hold up. 60mph in 3rd should do it. Maybe ill get lucky and find a...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-25-2019, 12:08 AM
    64GunPilot replied to a thread Facilities & Etiquette in General
    Bryan, thanks for the advice. Agreed on all. 1/2 tons are not the best for what we pull. The Trailer: I agree a 20ft enclosed isnt much...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-22-2019, 08:39 PM
    64GunPilot replied to a thread Facilities & Etiquette in General
    Ok. I see i'll eventually need to buy a new generator. I have a lot of things I need. Unfortunately I can't buy it all at once. I gotta start off...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-22-2019, 06:29 AM
    64GunPilot replied to a thread Facilities & Etiquette in General
    So what is the etiquette for running generators at night after campfire gatherings ? My current generator runs about 75db. Pretty loud. Or do...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-21-2019, 12:00 PM
    64GunPilot replied to a thread Facilities & Etiquette in General
    Nice. Have considered some older v10 class C motorhomes too. But doing a little work to put in a shower / rv toilet and some electrical work for...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-21-2019, 12:25 AM
    64GunPilot replied to a thread Facilities & Etiquette in General
    I see. Thanks. So you have like a little tent popup shower type deal that you shower in? Cool. I've been pitching around the idea of mildly...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-20-2019, 12:20 PM
    A couple general track questions regarding track events, facilities, hookups, and etiquette. Is it ok to spend the night in your racecar...
    30 replies | 988 view(s)
  • 64GunPilot's Avatar
    01-14-2019, 09:49 AM
    64GunPilot replied to a thread MSRH Roll Call in Upcoming Events
    Still in SK. Would be nice if someone can upload a video or two and some pics. Share it so others can see.
    51 replies | 1673 view(s)
  • 64GunPilot's Avatar
    01-12-2019, 08:14 PM
    Maybe the switch position could be documented in the remarks on the dyno sheet? IDK. Seems silly but then again, while I have read all of the rules...
    43 replies | 1772 view(s)
  • 64GunPilot's Avatar
    01-11-2019, 07:11 PM
    I didnt think of that. This was already setup on the CMC car I just bought.
    43 replies | 1772 view(s)
  • 64GunPilot's Avatar
    01-11-2019, 03:34 AM
    Not sure what platform you are running, but on my car and I've seen this on other cars too....the Engine Temp Sensor wiring is rerouted to a switch...
    43 replies | 1772 view(s)
  • 64GunPilot's Avatar
    01-07-2019, 08:28 PM
    64GunPilot replied to a thread Power steering fluid in Engine
    Funny you say this, my Hyundai Trajet (Korean Minivan with a 2.0 common rail turbo diesel) also just sprung a power steering leak. Right when I am...
    6 replies | 262 view(s)
  • 64GunPilot's Avatar
    12-30-2018, 06:39 PM
    On my 40ft enclosed, for $30 off ebay, I bought a cheap camera and a 50ft RCA video cable. My Excursion already has an aftermarket double din 7 in...
    15 replies | 845 view(s)
  • 64GunPilot's Avatar
    12-30-2018, 12:01 PM
    I now own 3 trailers. This 20ft Enclosed with soon to be new tires: This 40ft triple axle Enclosed: And this flatbed: So keeping up...
    15 replies | 845 view(s)
  • 64GunPilot's Avatar
    12-28-2018, 08:02 PM
    I guess this was before safer barrier. This would probably hurt a little: https://www.youtube.com/watch?v=jxtID4k3UBw...
    34 replies | 2426 view(s)
  • 64GunPilot's Avatar
    12-28-2018, 07:14 AM
    Can CMC cars run wide open around the oval? That video looks scary!
    34 replies | 2426 view(s)
  • 64GunPilot's Avatar
    12-28-2018, 06:01 AM
    Thanks. I did not realize how long this post was and I feel a little retarded posting it. Anyways. Mike called me just a few hours ago, and he...
    15 replies | 845 view(s)
  • 64GunPilot's Avatar
    12-27-2018, 01:02 PM
    Warning, long read and boring to some but is a simple blog of the final purchase steps and taking possession of my new CMC 3rd gen Camaro. Please...
    15 replies | 845 view(s)
  • 64GunPilot's Avatar
    12-27-2018, 12:30 PM
    What kind of speeds do yall see on the roval here? And what constitutes the COST differences between different venues (COTA Roval ect)
    34 replies | 2426 view(s)
  • 64GunPilot's Avatar
    12-18-2018, 08:49 PM
    64GunPilot replied to a thread Coleman Brakes in General
    http://www.colemanracing.com/Brake-Rotor-8-Bolt-7-Directional-Vane-P4670.aspx 24837 and 24838 are the rotors ill be running since thats whats on the...
    15 replies | 930 view(s)
  • 64GunPilot's Avatar
    12-16-2018, 07:55 PM
    64GunPilot replied to a thread Coleman Brakes in General
    Thanks for the insight. I am asking a lot of questions now that will likely be answered with time around you guys at the track during the HPDE days...
    15 replies | 930 view(s)
  • 64GunPilot's Avatar
    12-16-2018, 08:38 AM
    64GunPilot replied to a thread Coleman Brakes in General
    Talking to Mike Plum (the previous owner) he said the rotors last about 1 season. Thats $175 per season for rotors. Economics seems good I think. ...
    15 replies | 930 view(s)
  • 64GunPilot's Avatar
    12-16-2018, 08:32 AM
    May 3-5 COTA
    34 replies | 2426 view(s)
  • 64GunPilot's Avatar
    12-11-2018, 11:42 AM
    I have what you need in storage but I wouldnt be able to get it to you until April. I bought stock Camaro LT1 manifolds about 7 years ago when I had...
    3 replies | 234 view(s)
More Activity
About 64GunPilot

Basic Information

About 64GunPilot
Location:
Killeen, TX

Statistics


Total Posts
Total Posts
62
Posts Per Day
0.53
General Information
Last Activity
Today 04:38 AM
Join Date
10-21-2018