LT1 motor with Canton pan

[Pranav]

Got this motor I bought off Sean last Summer and ran for one weekend at Hallett before I gave up on optisparks.

Sean had built it and test started it once, but it didn't get used until I put it in my car.

It's a 0.020 over motor with ls7 lifters, guide plates, hardened pushrods and good bearings.

Came in at above 80% leakdown on the engine stand on dry cylinders and produced a clean oil filter after hallett. Ran great before I pulled for the ls swap.

This weekend I'm going to pull the Canton pan and HV pump before loading it in the back of the truck and dumping it on CL.

$1200 with the canton setup.

Still got tons of LT1 odds/ends that I haven't had time to go through yet.