T5 Replacement in 94 Mustang

[Sook]

I think summit has them in stock. I usually check their stock when we race at Cresson because... well... CMC car.

Going between T5 and TKO on mine is trans, shifter, bell housing, sometimes shimming the clutch pivot. You'll need a 26 spline clutch for the TKO600. My driveshaft and trans mount work for both, that may be different on an sn95.

I've had the T5z and the TKO in and out of the car several times this season.

- Josh

[Sook]

Dederich might also have a 600RR for you.

http://www.dederichsmotorsports.com/...transmissions/

- Josh

[centerville]

I forgot about the shifter, thanks.

Now this is starting to feel like racing. Trans change is half the cost of the car. I am hoping I won't have to alter drive shaft as I would like to get the t5 rebuilt better for a backup.

Dederich is close to me so I will go talk to him first.

Thanks guys!

[drecords]

If you're adventurous T5 is not a bad rebuild. I did mine myself (T5WC) before I bought Marshall's Astro. That was before Craig had MDT though, he's reasonably priced, has beer on tap, and does top notch work!

I forgot about the shifter, thanks.

Now this is starting to feel like racing. Trans change is half the cost of the car. I am hoping I won't have to alter drive shaft as I would like to get the t5 rebuilt better for a backup.

Dederich is close to me so I will go talk to him first.

Thanks guys!

[Supercharged111]

I forgot about the shifter, thanks.

Now this is starting to feel like racing. Trans change is half the cost of the car.

Thanks guys!

If it makes you feel any better I'm going to do a rebuild on my T56. Unless I destroyed something I think I'm on the hook for like $500.

[Al Fernandez]

Oh it’ll be much more than that if you allow Sean to decide which parts need to be replaced.

[Supercharged111]

Oh it’ll be much more than that if you allow Sean to decide which parts need to be replaced.

I heard the bearings were a pain, so no thanks. Carbon blocker rings, steel 3-4 fork, billet keys and send it. Now that the pilot bearing exists it's raceable, but I can't slam gears as fast as I like. Not coming to Hallett again next year with my pants down.

[Fbody383]

I heard the bearings were a pain, so no thanks.

What's hard about the bearings? The input shaft blind hole bearing is the only one to consider hard. If they look good fine. If they look bad, and are bad, why would you leave them in there?

[Storm Trooper]

Oh it’ll be much more than that if you allow Sean to decide which parts need to be replaced.