T5 Replacement in 94 Mustang

[martinsntx]

I got mine from liberty gear, same price that you found. Recommend the carbon syncros. The factory SN95 mount will not work. The drive shaft length did not change for me going from the T5 to the TKO.

[Trublu]

Add to that a bell housing, clutch, shifter and a fair chance you'll shorten the driveshaft. Recommend REM polishing and using Tremec fluid

[Sook]

I think summit has them in stock. I usually check their stock when we race at Cresson because... well... CMC car.

Going between T5 and TKO on mine is trans, shifter, bell housing, sometimes shimming the clutch pivot. You'll need a 26 spline clutch for the TKO600. My driveshaft and trans mount work for both, that may be different on an sn95.

I've had the T5z and the TKO in and out of the car several times this season.

- Josh

[Sook]

Dederich might also have a 600RR for you.

http://www.dederichsmotorsports.com/...transmissions/

- Josh

[centerville]

I forgot about the shifter, thanks.

Now this is starting to feel like racing. Trans change is half the cost of the car. I am hoping I won't have to alter drive shaft as I would like to get the t5 rebuilt better for a backup.

Dederich is close to me so I will go talk to him first.

Thanks guys!

[drecords]

If you're adventurous T5 is not a bad rebuild. I did mine myself (T5WC) before I bought Marshall's Astro. That was before Craig had MDT though, he's reasonably priced, has beer on tap, and does top notch work!

I forgot about the shifter, thanks.

Now this is starting to feel like racing. Trans change is half the cost of the car. I am hoping I won't have to alter drive shaft as I would like to get the t5 rebuilt better for a backup.

Dederich is close to me so I will go talk to him first.

Thanks guys!

[Supercharged111]

I forgot about the shifter, thanks.

Now this is starting to feel like racing. Trans change is half the cost of the car.

Thanks guys!

If it makes you feel any better I'm going to do a rebuild on my T56. Unless I destroyed something I think I'm on the hook for like $500.

[Al Fernandez]

Oh it’ll be much more than that if you allow Sean to decide which parts need to be replaced.