What gear are you switching too? GM gears I think are preferred but would look at Motive.
Bryan Leinart
CMC #24
I don't know man...I'm looking at 4.11's but I'm hampered by the 5900 limiter. you got that extra 300 rpm I would certainly punt someone for. what rear end are you running? 10 bolt? Richmond makes a solid product as does Yukon but to be honest, at our HP levels they are all good enough. It all comes down to setup when it is installed. either way, do your best to stay slow! LOL!
Ah, fugg it.
After 6 seasons on a 3.42 I did a bunch of analysis on my gps speed/rpms/shifts on my 6100 rpm ls and came to the conclusion that 3.90 was good for all tracks except nola, cota, and tms, for which I would need a 3.23
So I will be swapping gears for those two categories of tracks
I'll need to check but hallet looked like a 4:10 track but I'm not about 3 rear ends
Haven't had a chance to try these gears out because some dude in china ate an undercooked bat and I got more busy at work
Last edited by Pranav; 12-19-2020 at 01:10 PM.
I have a 3.90 gear now and it's too much for me at MSRH and ECR unless I can run the car to 6500 which is also out of my power band. On the long straights it puts me in 5th gear at the very end which I don't like. Feel like the 3:73 would be just a little better so I didn't have to worry about an additional shift. Though the 3:90 certainly pulls me out of a corner great, felt like my car was a rocket on the straights at ECR when I go it right. It could certainly be driver error but it feels like the car unloads a bit in 5th and make me a bit more unstable when braking.... plus I'm not the best at 5th to 4th downshift for some reason (need more practice). I'll most likely build up a new axle assembly to test so it can easily be swapped... why not, right?
Crap maybe i screwed up lol
Bookmarks