Results 1 to 4 of 4

Thread: Overheated aluminum 4.6 engine, is it trash?

  1. #1
    Member Rookie fscott's Avatar
    Join Date
    Feb 2021
    Location
    Round Rock, TX
    Posts
    57

    Overheated aluminum 4.6 engine, is it trash?

    You all probably know already, back in March I ran my Mustang on the track without coolant (because I was an idiot).

    It overheated, valves siezed up, and that was all she wrote.

    I'm trying to decide what to do with the engine at this point. I could get the heads remachined. The pistons, bores, and block appear OK. However, I'm concerned about the metallurgy changing, and about the block warping.

    Should I even attempt to save this motor, or should I scrap it?

  2. #2
    Senior Member Carroll Shelby
    Join Date
    Mar 2012
    Location
    Houston
    Posts
    1,449
    Blog Entries
    2
    I hate fucking with engines that have had shit happen to them.

    I had cooling issues with my first lt1 block that were never fixed until I threw it away and started over with a new one.

    How much is a core long block used? Always better to start with a never taken apart salvage pull and let a machine shop take it apart go through it the way they want to.

  3. #3
    I can't answer your question but I'm running a tired 4.6 and am planning a new build this winter. Recently I bought a running junk yard 2002 Explorer engine and plan to use that block/heads on the new build (after a machine shop preps them). They came with aluminum blocks and PI heads. You could do the same, starting over with parts that haven't been "cooked". Cost me about $300 for the engine.

  4. #4

    Post

    Quote Originally Posted by fscott View Post
    You all probably know already, back in March I ran my Mustang on the track without coolant (because I was an idiot).

    It overheated, valves siezed up, and that was all she wrote.

    I'm trying to decide what to do with the engine at this point. I could get the heads remachined. The pistons, bores, and block appear OK. However, I'm concerned about the metallurgy changing, and about the block warping.

    Should I even attempt to save this motor, or should I scrap it?
    I think to really know if they've changed from a metallurgical standpoint, you have to know where you started.

    If I was worried about it, I would not spend the money on getting questionable parts machined. Maybe talk to the machinist and see what they think. Luckily, we're not very hard on equipment in CMC /s.
    CMC #50

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •