Sorry did not check the forum in a few days. This sums up the steering column on my car:
"It's literally just a rack swap... but the u-joint on the end of the column is smaller than the rack output shaft. We tried just swapping it in the car and ended up pulling the column to be able to test fit it. I think he's on a third rack trying to find one that fits"
In looking for guidance and this thread presently might be best to have the initial column rebuilt instead of trying new ones. And hopefully ready for ECR on 03-05 Dec 2021. Getting this deep into it is a bit much for my mechanical abilities.
Bookmarks