Got a nice dent pulling slide hammer set and got to work on my inner fender and core support, but to my surprise the attachment it came with isn't setup for weld-on draw pins:
http://ecx.images-amazon.com/images/...L._SL1451_.jpg

Got a used stud welder and a pack of draw pins ready to go, just need to figure out what the heck the "pin puller attachment" is called and where I can find one:
http://ecx.images-amazon.com/images/...rL._SX425_.jpg

Was hoping to avoid buying a second slide hammer dedicated to draw pin pulling but I may have to do that:
http://www.eastwood.com/heavy-duty-s...RCCODE=1SE1529

Anyone know what I'm talking about?

Got it halfway all lined up, just need to pulled out some of the curved sections with draw pins to finish it up...

Body work sucks...