MikeP99Z
08-11-2009, 03:22 PM
I have a Wilwood 6-piston setup that I tested on my car a few years back.
Front brake kit for an F-body (dunno if it will work on a Ford) 6-piston calipers, slotted rotors with aluminum hats (i can measure exactly if needed - either 13.06" or 12.88"), SS lines, brackets, some brake pads (I can figure out what they are if needed) and LS1 spindles (cut ears for the kit install). The kit takes the 16mm brake pads. I think the kit will only work with 17" wheels.
Most stock calipers I believe take the 20mm pad (my Stoptechs do for instance).
I was going to save the kit for a CMC2 build, but I don't forsee myself going that direction anytime soon.
$800 (I think the kit is around $2k new, and then you have to modify your spindles). Feel free to check Wilwood's website.
Front brake kit for an F-body (dunno if it will work on a Ford) 6-piston calipers, slotted rotors with aluminum hats (i can measure exactly if needed - either 13.06" or 12.88"), SS lines, brackets, some brake pads (I can figure out what they are if needed) and LS1 spindles (cut ears for the kit install). The kit takes the 16mm brake pads. I think the kit will only work with 17" wheels.
Most stock calipers I believe take the 20mm pad (my Stoptechs do for instance).
I was going to save the kit for a CMC2 build, but I don't forsee myself going that direction anytime soon.
$800 (I think the kit is around $2k new, and then you have to modify your spindles). Feel free to check Wilwood's website.