WTB rear caliper brackets from LS car

[Rsmith350]

Need a set of stock caliper brackets from the rear of an LS car. Anybody who has done a big brake kit should have some

[MikeP99Z]

Factory rear brakes are on most of the F-bodies racing here. I'd try Craigslist, LS1Tech, or the wrecking yard.

[Dulaney]

Many would argue the use of LT1 brakes, as they're less effective, and therefore less to dial out with pressure.

[Rsmith350]

Thanks guys, using LS calipers due to no Ebrake setup. Just simpler. LT brackets won't work. Apparently Oreillys has them for $30 bucks so no big deal. Have brake bias controller to dial them out. I do however need the remote adjuster from Wilwood

[Rsmith350]

So, note to anyone trying to do this, the backing plates are different on the rear end. Will not fit without yanking axles and finding right backing plates

[AI#97]

Try the wrecking yard and just get the whole housing. When I was converting misty's car back to LS1 rears, I could not find ANY of the backing plates or if I did, they wanted $135/ea for them. I ended up getting an entire rear housing with the correct 3 channel abs stuff for $175 at the local wrecking yard. Ended up just dropping the eaton into that housing and rocked on with newer axles too.

Look at V6 cars too as I think the 99+ V6's all shared the same rear end setups....maybe just different gears.