Fuel Jug Caps

[BryanL]

I only have one cap for my fuel jugs that was threaded with a few adapters, small piece of clear hose and a plastic end on it that would fit in the stock tank and was also threaded so I could cap it off. That busted in the trailer to Houston. Does anyone know if there are plastic fittings and hose available at HD or somewhere to get a new setup going? I think my old setup may have ended up in the trash. So I need something that will screw into the plastic female of the cap so I can get a hose setup.
I'm going to look online for premade caps to see if they are available without the jugs.

[Pranav]

Are you talking about this?
http://www.amazon.com/VP-Racing-Fuels-3044-Deluxe/dp/B005G5R5LQ/ref=sr_1_1?m=A2IS69AN9A0OWP&s=automotive&ie=UTF8&qid=1422634948&sr=1-1&keywords=vp+racing+fuel+hose&pebp=1422634951570&peasin=B005G5R5LQ

I think I have a couple laying around, I wanna say I got them for a way better price than the above...

[Pranav]

But yes you can make your own using PVC pipe fittings from home depot, just need to figure out what your thread pitch is in the cap if it's not a VP racing jug cap (scribner?)

[BryanL]

Awesome Pranav. Yes, that is exactly what I have. Only issue is the lack of flex in the hose on that setup but that looks exactly what I have and got them from PST. They are Scribner jugs. Also have some VP jugs that I borrow from my old man for race weekends. I don't know if the thread pitch is different. I'll take the cap to HD and see what if I can find the right male pipe fitting.
Thanks.

[GlennCMC70]

3/4 npt.

[Pranav]

At Home depot they will be marked as 3/4 MIP for male and 3/4 FIP for female. Translates to NPT...