Car prep weekend ...

[mitchntx]

To do list ...

R&R trans - complete
R&R rear brakes - complete
Clean out Houston from inside the car - complete
Install AC - complete
Nut-n-Bolt - complete
Prep trailer - complete
PST for new tires - complete
Oil change on tow rig - complete
Drink beer - in progress

Damn ... I'm tired ...
:?

[michaelmosty]

Mitch,
It sounds like you have been working too hard, take a break and drink a beer.

[AllZWay]

All I had left to do this weekend :

Mount 2 new tires...Check
Install Lawmotorsports stickers... Check
Clean windows..... Check
Bleed brakes..... on hold pending Dad's help later today.

[GlennCMC70]

i may wash the car tomorrow. :roll:

[jeffburch]

New gear.
New oil pump.
Rebuilt tranny, + another new 5th gear.
New style CC plates.
New hubs/bearings/rotors/calipers/pads.
Front spring change.
Reset camber/caster/toe/bump.
Moved seat down/right.
New (homemade) SFC's.
Tweaked front fenders.
Removed side mirrors.

Need to heat cycle 3 new sets of tires including rains and my new brake package X2.
Doing the T&T friday I hope.

jb

[AI#97]

Roll car out of garage complete with Houston grit still on it....check.
Put in trailer to go testing....check
Beat the piss out of it on the 1.3 at cresson....check

Car performed flawlessly so here is the new checklist to be done by thursday.

1. Install oil cooler.....maybe.
2. put air in the tires.
3. put gas in the car.
4. Check oil level.
5. Clean air filter.
6. remove mufflers cause I want to get people in Navasota to come see the races.
7. Put car in trailer for TWS

Once on track:

1. Stay out of the new "Mosty Vortex"
2. Count the number of winged cars on track....might need two hands! :wink:

[marshall_mosty]

1. Stay out of the new "Mosty Vortex"
2. Count the number of winged cars on track....might need two hands! :wink:

My checklist since the last event...

Done
1. Design new "Fulcrum Motorsports" prototype rear wing and uprights. (Check)
2. Fabricate new "Fulcrum Motorsports" prototype rear wing and uprights. (Check)
3. Install wing and uprights. (Check)
4. Fabricate "Pedersen" style splitter with a few tweaks. (Check)
5. Install splitter at track. (Check)
6. Go to Cresson and knock off 1.5 seconds of personal best, getting consistant low 1:23's. (Check)

Still need to do:
7. Finish little tweaks of front splitter
8. Bleed Brakes
9. Paint Splitter
10. Wash Car

[AI#97]

6. Go to Cresson and knock off 1.5 seconds of personal best, getting consistant low 1:23's. (Check)

I snuck over to the office a couple times to check how you were doing..never got a chance to tell you "good job!" Bet the car felt totally different!

[marshall_mosty]

Thanks Matt, hopefully that will equate to something good this weekend.

[donovan]

2. Count the number of winged cars on track....might need two hands! :wink:

Nothing to see here... move along... 8)