Test Day 9-3 at MSR-C? anyone else gonna be there?

[GlennCMC70]

i'll be there at 7-8am tomorrow bedding in new tires, rotors and a freshly built trans so i will not have to do any of this at Mid Ohio.
is anyone else gonna be there? its possible i could use some help w// hot tire temps and pressures and hopefully nothing else. Nick R said he may be able to come out and help.

hell there may even be a free lunch in it for ya. :wink:

[donovan]

I was at TWS testing... ;-)

New Engine, New Tranny, New Rearend... New rotor, bedding in pads... a a few other things...


DD

[michaelmosty]

So how did the testing go for both of ya'll?

[donovan]

I was at TWS testing... ;-)

New Engine, New Tranny, New Rearend... New rotors, bedding in pads... a a few other things...


DD

[donovan]

I was at TWS testing... ;-)

New Engine, New Tranny, New Rearend... New rotors, bedding in pads... a a few other things...


DD

Everything went very well... could not be happier with the testing...

The new engine was awesome!!!

I now have plenty of TQ to get out of the corners!!! ;-)

DD

[GlennCMC70]

1:25.5
heat cycling new tires and new rotors. :P

[marshall_mosty]

DD,
I heard you laid down some impressive numbers on the rollers before dialing it back to meet your race weight. Awesome!!

[donovan]

I still need to get on a dynojet... the tuning was done on a Dyno Dynamics Dyno...

Well, the current numbers are dead nuts on for a 20 minute race... for a 40 minute race I will need to add some weight... all to be officially determined when I get the dynojet numbers.

8) DD

[michaelmosty]

It sounds like all the CMC and AI racers outside of Texas are going to have a sad drive home from Ohio. 8)

[jeffburch]

DD,
I'd twist the one at MO when you get there.
I am. GL is.
jb