....pull me down the straights now.
muahahahahaha
http://www.tek-racing.net/cmc17/CMC17-DYNO.wmv
What? You want the numbers too?
:lol: :lol: :lol: :lol:
....pull me down the straights now.
muahahahahaha
http://www.tek-racing.net/cmc17/CMC17-DYNO.wmv
What? You want the numbers too?
:lol: :lol: :lol: :lol:
Cough em up there Champ!
Lets those monster numbers
I heard you were moving to AIX! ;-)
John G.
www.chicane23store.com
http://www.chicane23.com/chicane23/i...ane23_ban1.gif
Maximum Motorsports, Griggs Racing, G-Stream Wings, Brembo, Canton, Fuel Safe, Toyo Tires, Hoosier, Koni, StopTechPit Pal, etc.
2004 & 2005 American Iron series Champion
224hp
294tq
:shock: 8) :lol:
muahahahaha
CMC car... :shock:
Slap some AI letters on there...
All that time, effort and money for 8hp and to chase a $2 medal?Originally Posted by CMC17
:roll:
8)
Almost 30tq though (pulled 266tq at cresson). It was needed work...trust me. lolOriginally Posted by mitchntx
It's going to make a HUGE difference.....my neighbors seem to think so too as I came around the corner today.
:P :P :P :P :P :P :P :P :P
Wow, nice.Originally Posted by CMC17
I had the day off from work as well.
I dyno tested a new margarita maker while sunnin' my noggin on the deck.
Hey Boudy!!
Check this out!
http://www.texicanracing.com/nasatx/...ender_rev2.wmv
jb
P.O.S. my a**! :lol:
where do I get me one of them blenders?
-chris
pppuuuuuuaaaaaalllllllllllllllleeeeeeeeeesssssssss sss!!!!!!!!!!! :roll:
aint got nut'in on my 229.5 hp / 297 tq! :twisted:
i could pull the restrictor plate and give you AI guys a run in full CMC trim! :wink:
Bookmarks