are they still required?
if so, just so I'm clear, I would need a hole on the main hoop, rear braces, door bars, and a pillar bars??
are they still required?
if so, just so I'm clear, I would need a hole on the main hoop, rear braces, door bars, and a pillar bars??
2010 CMC2 National Champion
2010 Texas CMC2 Champion
2010 Summer Shootout Champion - CMC2
Call it what you want... But that sounds like a Triple Crown to me!!
http://www.gagemotorsports.com
Drill them if you need toOriginally Posted by jeremiahkellam
Mitch is spot on - only drill them when asked by an official. Let them point out where they need to be drilled.
thanks
2010 CMC2 National Champion
2010 Texas CMC2 Champion
2010 Summer Shootout Champion - CMC2
Call it what you want... But that sounds like a Triple Crown to me!!
http://www.gagemotorsports.com
For you Mustang owners, use an Oxy-Acetylene torch instead of a drill bit.
FYI - If there's a line in Tech, you will be asked to leave to drill the holes. You will have to go to the back of the line. Best advice is to get with an official prior to getting in line.
Bookmarks