Mustang wheel stud part number?

[BSharp]

What front and rear ARP stud parts numbers are you all using? The longer than stock ones?

[Rob Liebbe]

Check with Max Motorsports and Steeda - (Baer is where I get them) They are longer than stock, but can be cut down if needed. They have the proper shoulder diameter to press into stock hubs and axles.

[BSharp]

The MM part has their own part number (different for front and rear). Steeda sells the same part for front and rear. the front has to be drilled out. I am looking for cheaper sources.

[marshall_mosty]

Front
Drill/Ream to 39/64 and use ARP-100-7703

Rear
Press right in (ARP-100-7703)
$12.95 for set of 5 thru Summit

[BSharp]

Thanks for the part numbers. Looks like they are 3.5" long. ARP makes one special for Steeda that is 2.5" long but $6 ea. It would be nice to have a shorter one with the rounded end.

[AI#97]

Thanks for the part numbers. Looks like they are 3.5" long. ARP makes one special for Steeda that is 2.5" long but $6 ea. It would be nice to have a shorter one with the rounded end.

Especially when you need a DEEPER than DEEP socket to run lugs down with some wheels and no spacers to burn threads....you have to cut off the rounded end...