What front and rear ARP stud parts numbers are you all using? The longer than stock ones?
What front and rear ARP stud parts numbers are you all using? The longer than stock ones?
What was your takeaway?
Check with Max Motorsports and Steeda - (Baer is where I get them) They are longer than stock, but can be cut down if needed. They have the proper shoulder diameter to press into stock hubs and axles.
Rob Liebbe - Texas Region
Camaro, Mustang, doesn't matter to me, I'll race it.
The MM part has their own part number (different for front and rear). Steeda sells the same part for front and rear. the front has to be drilled out. I am looking for cheaper sources.
What was your takeaway?
Front
Drill/Ream to 39/64 and use ARP-100-7703
Rear
Press right in (ARP-100-7703)
$12.95 for set of 5 thru Summit
Marshall Mosty
AI/SI Texas Regional Director
2011 NASA-TX American Iron Champ
AI #67 "Mosty Brothers' Racing" (RIP)
ST6 #21 Toyota Corolla (being revived)...
Thanks for the part numbers. Looks like they are 3.5" long. ARP makes one special for Steeda that is 2.5" long but $6 ea. It would be nice to have a shorter one with the rounded end.
What was your takeaway?
Especially when you need a DEEPER than DEEP socket to run lugs down with some wheels and no spacers to burn threads....you have to cut off the rounded end...Originally Posted by BSharp
Ah, fugg it.
Bookmarks