Results 1 to 2 of 2

Thread: CMC #26 for sale (for reals this time)

  1. #1
    Junior Member Rookie
    Join Date
    May 2010
    Location
    CS, TX
    Posts
    23

    CMC #26 for sale (for reals this time)

    For sale: 1995 Camaro Z28 setup for the NASA Camaro Mustang Challenge road race class. This is a RACE CAR only: no title no VIN plate. Strictly track car

    Car is very close to race ready: seat needs to be mounted where you want it and it can hit the track. Only thing keeping it from passing annual tech is no fire system. Put in a fire system and it will pass tech. NASA logbook. Last annual tech 2022 (no fire system requirement last year). As far as I know car has never been wrecked, and I see no evidence that it has been twisted up. I have plenty of pics I can share.

    Car was on track this year. Selling because I've got too many cars and need to focus on one!

    - LT1/T56
    - 40 mm restrictor installed to meet CMC max power (dyno sheet available)
    - NASA logbook
    - NASA legal cage
    - 16" Kirkey seat (not installed)
    - New camlook driver harness expires 2026
    - Drivers window net valid until end of 2023
    - New center net valid until June 2025
    - Car does not have fire system, will need fire system installed to pass race tech
    - LS front brakes with brake cooling ducts
    - LT style rear brakes (less rear bias than LS brakes)
    - Rod end rear suspension (control arms/panhard bar)
    - Stock front control arm bushings
    - Bilstein racing shocks (CMC legal)
    - Ducted Cold Case Aluminum radiator
    - 3 sets OEM C5 Z06 17x9.5 wheel (best wheel for 4th gen CMC car)
    - Transponder mount and wiring for transponder power but no transponder included
    - Factory cluster still installed and working

    Tons and tons of new parts:
    - Brake master cylinder
    - Clutch
    - Clutch master and slave
    - Front and rear calipers/rotors
    - All 5 brake lines (new braided)
    - Rag joint eliminator
    - Rebuilt/de-flowed power steering pump
    - AN braided power steering lines
    - Power steering resovior
    - Power steering cooler
    - Oil cooler with fan
    - Oil cooler adpater with thermostat
    - Oil temp gauge with memory
    - UMI 36mm front bar with poly bushings
    - OEM 21 mm rear sway bar (new poly bushings), largest allowed for 4th gen
    - Opti spark with lock tite on bolts
    - Spark plugs
    - Spark plug wires
    - Crank hub
    - Front oil seals (water pump/opti/crank- no leaks!)
    - Crank underdrive pulley
    - Water pump
    - Brake master cylinder brace
    - Engine oil catch cans
    - Rear axle seals
    - Thicker rear axle c-clips to eliminate play
    - Coolant overflow tank
    - Solid motor mounts
    - Rear end catch can
    - Rear axle seals

    Tons and tons of spares included:
    - 2 complete posi LT rear ends with brakes
    - Factory y pipe (required for LT1 in CMC)
    - Torque arm
    - 94-95 computer with CMC legal tune for 3.42's
    - LT power steering pump
    - LT starter
    - LT alternator
    - New in box spark plug wires
    - New in box ignition control module
    - New in box coil
    - Used opti (confirmed working)
    - 1 new LT rear caliper bracket
    - 1 used front hub with ARP studs
    - 1 used front hub with no studs
    - 1 used front hub with stock studs
    - 1 set new in box LS Carbotech front XP10 pads
    - 2 sets used Raybestos front pads
    - 1 set NIB street rear pads
    - 3 used LS front calipers
    - 4 LS front rotors new
    - 2 used LS front rotors
    - 2 LT rear rotors new
    - Front bumper beam (no damage)
    - CMC legal rear springs (will have to check rate)
    - 10 bolt gears (3.42 i think, will have to check)
    - factory LT radiator shroud with fans

    All of the above is $9000. Car is located in Bryan TX. I can deliver for $1/mile round trip prepaid deposit.



    I've also got a ton of extras that I was gathering for the car. These are NOT included in the above price but we can negociate:
    - Spherical bearings for front lower control arms Global West (new in box)
    - Delrin front upper control arm bushings Global West (new in box)
    - UMI bump steer kit (new in box)
    - 2 sets C5/6/7 front wheel bearing adapters (new in box)
    - OEM LS1 k-member
    - Rebuilt LS T56 with zero miles (with paperwork)
    - Complete fully dressed LS longblock with accessories/intake/TB/injectors/manifolds
    - LS AL driveshaft with new u-joints
    - LS plastic gas tank with sending unit assembly
    - 2 LS complete dash shells in great shape
    - Nicer Kirky 16" intermediate road race seat
    - Another double rod end panhard bar (only 1 day on it)
    - Remote mount power steering reservoir for LS pump
    Attached Images Attached Images
    Last edited by Mojave; 06-14-2023 at 07:03 PM.

  2. #2
    Junior Member Rookie
    Join Date
    May 2010
    Location
    CS, TX
    Posts
    23
    Sold!!

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •