Crap...

Just noticed this while removing the heater and adding lightness to Knocker... passenger side Caster camber plate is bent.
http://www.fototime.com/inv/80FD8773AACA632

Don't know when it happened, but my guess is I dropped 2 right sides off and the shock bottomed out.

How do you go about fixing this? Obviously new c/c plates or for now go back to the factory ones. I'm more concerned about the body. The top of the mounting area should be flat, and the area around one hole has been pulled up maybe 1/4". Just hammer it back flat and be on my way or should I be shopping collision shops? Suggestions?


8.36.8. If slotted plates
are used, they shall be located on the existing chassis structure and shall not serve as
reinforcement for that structure. Some minor trimming of the chassis strut tower opening is
allowed to provide for additional suspension adjustment.
According to this, I can't reinforce this area but I can remove material?