lol. Actually, I noticed on the standing start, it was shaking all-over.
lol. Actually, I noticed on the standing start, it was shaking all-over.
Jim Dulaney
AI 117
Here is Race 1 start and 1rst lap forward facing
I will post up the rear facing so you can see the threesome at the start
http://youtu.be/d9fUXe-YHzc
Here is the in car version of my race 2 spin
http://youtu.be/d9fUXe-YHzc
Last edited by NASA13; 01-24-2014 at 10:51 PM.
Spin video:
http://www.youtube.com/watch?v=ikVej6aDuMk
-Michael Mosty
CMC #11 Mosty Brothers' Racing
Director - TX Region
Rebuild effort has started.
Some things can't be fixed... Will be calling Racecraft tomorrow.
Front bumper cover stitched together with aluminum plate and rivets.
Front fender stitch welded and pounded out. Ready for filler.
Rear quarter re-welded and ready for filler
Also dismounted all the RA1's and put the two damaged wheels aside for repair. The tire machine did NOT like to run over a broken rim lip...
Marshall Mosty
AI/SI Texas Regional Director
2011 NASA-TX American Iron Champ
AI #67 "Mosty Brothers' Racing" (RIP)
ST6 #21 Toyota Corolla (being revived)...
I got everything disassembled last week and took these photos. The car is scheduled to go on the frame machine early next week. This erratic (Texas) weather is messing up all of the body shop schedules. They can't paint when it is freezing, etc. Both frame rails are bent forward of the strut towers. The driver's side one is much worse, bent both inward and upward.
'86 Mustang Coupe - CMC2 34
Early indication is that I will need two new inner fender aprons. I have two options:
http://www.latemodelrestoration.com/...-Factory-Holes
http://www.latemodelrestoration.com/...mooth-No-Holes
Same price. Any chance the no-holes version is legal? They are otherwise identical. They would in theory be heavier (bad - on the nose), but also stronger (less swiss cheese - important to regain as much strength as possible)
Thoughts?
'86 Mustang Coupe - CMC2 34
Bookmarks