Rock auto has so many different hubs. Does it matter which one I order as I repacking them?
Rock auto has so many different hubs. Does it matter which one I order as I repacking them?
Never got any pics. I would appreciate any pics you could take Josh.
Ok I replacement hubs now. I can see how I can get the dust cover off the outside bearing. But I have no idea how I should approach the inside bearing. Anyone care to share so I don't screw them up. I got skf bearings if it matters. TIA
Here's a picture of the tool Richard P. made. I tried to take out the dust seal from the back of this bearing, but it didn't come out properly. Insert the wedged part of the tool into the inner race of the bearing, make sure not to grab both races. Apply some bending moment to the tool and it should pop out easily. pull all the guts out and the outer race should also pop out easily, sometimes even without the tool. Regrease with your grease of choice!
20180604_214439.jpg
Hub opening tool. One side is for SN95+ hubs, the other is s197 hubs.
20180604_214634.jpg
Tighten the wedge bolt.
20180604_215401.jpg
Dust seal didn't come out properly. I was able to tap this ring back in to cover the dust seal without issue.
I ended up with Timken branded bearings this time around. I wasn't able to get them apart at all, even after using implements of great force. The last set that I did for my S197 were very easy to take apart, so I guess these are different some how. I would not recommend these bearings for CMC. They might have already failed after Hallett, so maybe I'll get to take better pictures soon.
- Josh
Last edited by Sook; 06-30-2018 at 03:21 PM.
CMC #50
Thanks Josh! I have work to do now.
Man, that looks way more involved than the 4 bolts that hold my hubs on.
RM CMC Director
Bookmarks