Quote Originally Posted by GlennCMC70 View Post
So do it in the car?
If not, then duplicating pinion angle is surely important. The axle should also be level when doing this - right? Obviously
Remove the oil?
Where onthe tube do you heat? Center point on the tube or closer to the center section?

I did it out of the car with the axle sitting on the tires. I used a jack under the snout to set the pinion angle. Level is important to take accurate camber measurements. Having the oil out probably isn't a bad idea. I heated in the center of each axle tube.

I know other people that have done it in the car. That souned challenging and not all that safe.


Richard P.